MasterCraft X-15 Manual de instalación descargar pdf (Pagina 5)

Installaon manual and user guide MasterCra / Holland Marine Parts 5

Safety:

read this prior to installaon or operaon.

This installaon manual provides advice about the complete installaon of the Jet Thruster.

Remarks about safety are accompanied by this symbol.

In rare condions it might be possible that the pump unit of the Jet Thruster does not prime. If you noce a high rpm from the

pump unit and no thrust force, do not aempt to prime the pump unit by connuous acvang the system. In this situaon the

Electrical air valve from Holland Marine Parts should be installed to release the air from the pump head. This will prime the pump.

Do not run the pump unit without the presence of water!

Follow all instrucons in this manual. All users of the system must be aware of the mandatory safety

regulaons as explained in this manual:

- Preferably leave installaon and maintenance of the system to a dealer authorised by Holland Marine Parts.

- Use appropriate tools for the installaon and maintenance of the Jet Thruster.

- Provide the Jet Thruster seperate baery.

Place the baery as close to the pump unit of the Jet Thruster as possible.

- Always use a Holland Marine Parts control panel.

- Do not touch any moving parts of an acve system.

- Parts such as the DC pump motor may become hot: do not touch them and do not cover them under any circumstances.

- Avoid having ammable products near the DC pump motor.

- Do not conduct any inspecon or maintenance of the system when it is acve.

- Do not close any valves of an acve system.

- The system is located beneath the water line. Do not remove any parts of the system before all valves have been closed.

- Close all valves when you are not aboard.

- Leave system maintenance to specialists.

- Disconnect the baery cables when conducng maintenance and in the event of long-term absence

(e.g. when the vessel is not being used in winter).

- The hoses are under pressure in an acve system: high-pressure hoses are to be aached to the vessel

to prevent movement along e.g. sharp edges.

- Protect the high-pressure hoses from heat / penetraon / sunlight / chemicals.

- Avoid physical contact with the water inlet when the system is acve.

- Avoid physical contact (swimmers!) with the nozzles and the water expelled by an acve system.

- Danger! Protect pump unit and 3-way valve from petrol fumes.

Provide sucient venlaon. Ignion proof covers are available.

1 2 3 4 5 6 7 8 9 10 ... 25 26

Sin comentarios

MasterCraft X-15 Manual de instalación Pagina 5